Sale Alert!

Check out our latest deals! NEOPAR®


  Home > Farm Direct > Farm Supplements / Nutritionals > Implants >

Component E-H
Component E-H
Component E-H


 
Component E-H, by Elanco, is for use in heifers weighing 400 lb. or more for improved growth promotion and feed efficiency. Testosterone propionate USP 200 mg and estradiol benzoate 20 mg. No slaughter withdrawl .

Item# Item Name Our Price Qty Add
843-018141 Component E-H with Tylan 100ds
$144.99
Check the items you wish to purchase, then click


:

COMPONENT® E-H

testosterone propionate USP 200 mg and estradiol benzoate 20 mg

Each CARTRIDGE BELT holds 20 doses of COMPONENT® E-H Implants. Each dose of 8 pellets contains a total of 200 mg testosterone propionate USP and 20 mg estradiol benzoate. COMPONENT® E-H Implants are recommended for use in heifers weighing 400 lbs or more for INCREASED RATE OF WEIGHT GAIN AND IMPROVED FEED EFFICIENCY.

COMPONENT® E-H WITH TYLAN®

testosterone propionate USP 200 mg and estradiol benzoate 20 mg with 29 mg tylosin tartrate as a local antibacterial

Each CARTRIDGE BELT holds 20 doses of COMPONENT® E-H Implants. Each dose of 9 pellets consists of 8 pellets containing a total of 200 mg testosterone propionate USP and 20 mg estradiol benzoate plus 1 pellet containing 29 mg tylosin tartrate as a local antibacterial. COMPONENT® E-H Implants are recommended for use in heifers weighing 400 lbs or more for INCREASED RATE OF WEIGHT GAIN AND IMPROVED FEED EFFICIENCY.

Ivy Animal Health

BRAND IMPLANTS

HEIFER IMPLANTS

Do not use in veal calves. Effectiveness and animal safety in veal calves have not been established.

For Use In Animals Only

DOSAGE: Administer 1 implant per animal according to the following instructions.





Extended Information:

IMPLANTING INSTRUCTIONS:

Loading the Implanter

Load the Implanter following the instructions supplied with each implanter.


Restrain the Animal

Speed of implantation as well as safety of handlers is best achieved by restraining animal in a squeeze chute using head restraint. When implanting horned cattle, better control is obtained with additional use of nose tongs.


Prepare the Implant Site

Scrub the back side of the ear (implant site) with a piece of clean absorbent cotton which has been soaked with a germicidal solution. Follow manufacturer's directions on germicide for correct strength and preparation of solution. Avoid getting into animal's eyes.

Where to Implant

The full contents of one cartridge cell should be implanted beneath the skin on the back side of the middle one-third of the ear as illustrated in the drawing. The implant must not be closer to the head than the edge of the auricular cartilage ring farthest from the head. The location for insertion of the needle is a point toward the tip of the ear and at least a needle length away from the intended deposition site.

Avoid injuring the large arteries, veins and cartilage of the ear.


Insert the Needle

With one hand firmly grasp the ear. With other hand insert needle point through the skin and ease forward on a lateral plane until the entire length of the needle is under the skin.


Implant the Pellets

After inserting the needle fully in the correct implant position squeeze the trigger fully. As the needle is withdrawn from the ear, the controlled-pressure plunger action properly deposits the implant in the needle track. This procedure should prevent breakage or crushing of pellets if otherwise forced into contact with tough fibrous-tissue underlying the skin. The length and total contact area of a single dose are designed to permit absorption of the hormones after implantation to stimulate good weight gain. Broken or crushed pellets may interfere with rates of gain and may lead to undesirable side effects such as noted in the Caution.

Clean the Needle

Clean the implanter needle with alcohol or a properly diluted germicidal solution prior to implanting the next animal.

Storage Conditions

Store at controlled room temperature 15° to 30° C (59° to 86° F)

DO NOT refrigerate - avoid excessive heat and humidity.

NADA 135-906, Approved by FDA

Manufactured by a non-sterilizing process.

*U.S. Patent No. 4,531,938

**U.S. Patent Nos. 4,762,515 & 5,522,797 - Ivy Animal Health, Inc.

COMPONENT E-H with Tylan is covered by U.S. Patent No. 5,874,098

COMPONENT and COMPONENT One Gun are registered trademarks of Ivy Animal Health, Inc.

Tylan is a registered trademark of Eli Lilly and Company.

Manufactured for VetLife by Ivy Laboratories, Overland Park, KS 66214, USA

VetLife and Ivy Laboratories are divisions of Ivy Animal Health, Inc.

01 22 01 02

NAC No.: 10330032




Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Farm Direct > Farm Supplements / Nutritionals > Implants

Google+
Social Tab
Are you a fan of A to Z Vet Supply?
:like>
Hide Bar

Read our latest blog post...