Have a question? Give us a call! 800-979-2869
Check out our latest deals!
STANDGUARD® PREMISE INSECTICIDE
[For Agricultural Use Only]
A controlled release premise insecticide
for use in and around livestock/poultry housing, pet kennels, railcars,
trucks and trailers for control of flies, fleas, mosquitoes, ants,
bees, wasps, crickets, pillbugs, scorpions, sowbugs, spiders, ticks and
Gamma-cyhalothrin: Cyclopropanecarboxylic acid, 3-(2-chloro-3,3,3-trifluoro-1-propenyl)- 2,2-dimethyl, cyan (3-phenoxyphenyl) methyl ester
Keep Out of Reach of Children
EPA Reg. No. 72642-3
EPA Est. No. 34704-MS-2
HAZARDS TO HUMANS AND DOMESTIC ANIMALS
Causes moderate eye irritation. Harmful if swallowed.
Avoid contact with, eyes, skin or clothing. Wash thoroughly with soap
and water after handling and before eating, drinking, chewing gum or
using tobacco. Remove and wash contaminated clothing before reuse. Wear
safety glasses or goggles, long-sleeved shirt, long pants, shoes and
socks, and chemical resistant gloves. Prolonged or frequency repeated
skin contact may cause allergic reaction in some individuals.
Skin exposure may also result in a sensation described
as a tingling, itching, burning or prickly feeling. Onset may occur
immediately to 4 hours after exposure and may last 2 to 30 hours,
without damage. Wash exposed areas thoroughly with soap and water.
Relief from skin sensation may be obtained by applying an oil-based
If swallowed: Call a poison control
center or doctor immediately for treatment advice. Do not induce
vomiting unless told to do so by a poison control center or doctor. Do
not give any liquid to the person. Do not give anything by mouth to an unconscious person.
If in eyes: Hold eye open and rinse
slowly and gently with water for 15-20 minutes. Remove contact lenses,
if present, after five minutes, then continue rinsing eye. Call a poison
control center or doctor for treatment advice.
Note to Physician: Induced vomiting
as a first aid for this product may result in increased risk of chemical
pneumonia or pulmonary edema caused by aspiration of the hydrocarbon
solvent. Vomiting should only be induced under professional supervision.
Have the product container or label with you when
calling a poison control center or doctor, or going for treatment. You
may also contact 1-800-428-4441 for emergency medical treatment
DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling
For use as a general surface (non-food/non-feed areas),
crack and crevice or spot treatment in and around livestock/poultry
housing, pet kennels, railcars, trucks and trailers. STANDGUARD
insecticide can be reapplied at 21-day intervals if necessary.
STANDGUARD insecticide is intended for dilution with
water for application using hand held or power operated application
equipment as a coarse spray for crack and crevice or spot and general
surface treatments. Application equipment that delivers low volume
treatments may also be used to make crack and crevice or spot and
general surface treatments. Fill the applicator tank with the desired
volume of water and add STANDGUARD insecticide. Close and shake before
use to ensure proper mixing. Shake or re-agitate applicator tank before
use if application is interrupted. Make up only amount of treatment
volume as required.
1. FLIES, FLEAS, MOSQUITOES, BEES AND WASPS:
Apply directly to walls, ceilings, window screens, and other insect
resting areas as a residual surface treatment. May be used in and around
equipment storage sheds; also see OUTDOOR SURFACE USE.
2. ANTS: Apply to ant trails around
doors and windows and other places where ants are found. Apply barrier
treatments to prevent infestations as directed in BARRIER TREATMENTS; also see OUTDOOR SURFACE USE.
3. SPIDERS AND CRICKETS: Apply as a
coarse, low pressure spray to areas where these pests hide such as
corners, storage areas, around water pipes, doors and windows, attics
and eaves and baseboards. Pay particular attention to cracks and
crevices; also see OUTDOOR SURFACE USE.
4. SOWBUGS AND PILLBUGS: Apply
around doors and windows and other places where these pests may be found
or where they may enter the premises. Treat storage areas and other
locations. Apply barrier treatments to prevent infestations as directed
in BARRIER TREATMENTS; also see OUTDOOR SURFACE USE.
5. LITTER BEETLES (Darkling, Hide and Carrion Beetles) in Animal Housing (such as Poultry Housing):
To control adult litter beetles, apply STANDGUARD insecticide to walls
and floors at each grow-out or sanitation procedure, before
reintroduction of poultry or other animals. This will suppress beetles
that escaped earlier treatment and will also help to delay the onset of
further infestations. Pay attention to areas where beetles frequently
occur, such as walls, supports, cages, stalls and around feeders; also
see LIVESTOCK/POULTRY HOUSING STRUCTURES.
Active ingredient concentration
Flies (including House flies, stable flies, little house flies)
0.0075% - 0.015%
0.16 fl oz (5 mL) / gal water
0.5 fl oz (15 mL) / 3 gal water
0.33 fl oz (10 mL) / gal water
1.0 fl oz (30mL) / 3 gal water
Note: Typical premise spray rates are 1 gal of diluted spray to treat 500 - 1000 sq. ft.
* For outdoor use only and use at 0.015% rate only.
Litter beetles** (including adults/immature stages of Darkling, Hide and Carrion beetles)
0.65 fl oz (20 mL) / gal water
2.0 fl oz (60 mL) / 3 gal water
** For control of light infestations of beetles, use 0.015% rate.
LIVESTOCK/POULTRY HOUSING STRUCTURES AND PET KENNELS
Apply as a general surface and/or crack and crevice
treatment. Control is enhanced when interior and exterior perimeter
applications are made in and around livestock, poultry and pet housing
structures. Normal cleaning practices of the structure must also be
followed along with applications of STANDGUARD insecticide to
effectively control the crawling and flying insects listed in the table.
For poultry houses, apply to floor area (birds grown on
litter) or to walls, posts and cage framing (birds grown in cages).
Application should be made into cracks and crevices around insulation.
Re-apply after each grow-out or sanitation procedure. Indoor control can
be enhanced by making perimeter treatments around the outside of the
building foundations to prevent immigrating beetles. Maintaining a year
round treatment program will prevent background populations from
reaching problem levels.
DO NOT make applications of
STANDGUARD insecticide in areas where animals are present in the
facility. Allow treated surfaces to dry completely before restocking the
facility. DO NOT make applications to any animal feedstuffs, water or watering equipment. DO NOT contaminate any animal food, feed or water in and around livestock, poultry or pet housing when making applications.
OUTDOOR SURFACE USE
For control of flies, fleas, mosquitoes, ants, bees,
wasps, crickets, pillbugs, scorpions, sowbugs, spiders, ticks and other
similar perimeter insect pests. Apply with either hand or power
application equipment as a residual treatment to surface of buildings,
screens, window frames, eaves and other similar areas. Also may be
applied to lawn areas around non-residential buildings, refuse dumps and
similar areas where these insect pests are active. Do not water the
treated area to the point of run-off. Do not make applications during
To help prevent infestation of a building, apply a band 6
to 10 feet wide around and adjacent to the building. Also, treat the
building foundation to a height of 2 to 3 feet where pests are active
and may find an entry into the building. Apply as a coarse spray to
thoroughly and uniformly wet the foundation and/or band area using 1-5
gallons of treatment solution applied to 800-1600 square feet.
NOTE: Do not use water-based sprays
of STANDGUARD insecticide in conduits, motor housings, junction boxes,
switch boxes, or other electrical equipment because of possible shock
hazard. For best results thoroughly wash out sprayer and screen with
water and detergent before using STANDGUARD insecticide.
- Let treated surfaces dry before allowing humans and pets to contact these surfaces.
- Do not use this product with oil.
- Do not allow applications to contact water inhabited
by fish, such as aquariums and ornamental fish ponds that are located in
and around structures being treated.
STORAGE AND DISPOSAL
Do not contaminate water, food or feed by storage or disposal.
Notice: Shake well before use. Avoid freezing.
Pesticide Storage: Store in original
container, tightly closed, in a secure place. Keep out of the reach of
children and domestic animals. In case of leak or spill, contain
material and dispose as waste.
Container Disposal: Nonrefillable container. Do not reuse or refill this container. Offer for recycling, if available.
Clean container promptly after emptying. Triple rinse as
follows: Empty the remaining contents into application equipment or a
mix tank drain for 10 seconds after the flow begins to drip. Fill the
container 1/4 full with water and recap. Shake for 10 seconds. Pour
rinsate into application equipment or mix tank or store rinsate for
later use or disposal. Drain for 10 seconds after the flow begins to
drip. Repeat this procedure two more times. Wastes resulting from the
use of this product must be disposed of on site or at an approved waste
disposal facility. Triple rinse empty container. Then dispose of empty
bag/container in a sanitary landfill, or, if allowed by state and local
authorities, by burning. If burned, stay out of smoke.
INTEGRATED PEST AND RESISTANCE MANAGEMENT
Flies, beetles and other insects have demonstrated
the ability to develop resistance to insect control products. Continual
exposure of flies and other insects to a single class of insecticide may
lead to the development of resistance to that class of insecticide. The
following resistance management strategy will help ensure the prolonged
usefulness of STANDGUARD insecticide, as well as other conventional
- Apply STANDGUARD insecticide and other insect control agents only according to label directions.
- Do not use less than the labeled rate of any insect control product.
- Include multiple control tactics (cultural and/or biological controls) within an Integrated Pest Management Program.
- Rotate STANDGUARD insecticide with other classes of
insecticide (naturalytes, phenyl pyrazoles, chloronicotinyls, and
organophosphates, etc.) during an insect pest season.
For advice concerning integrated pest management
practices in relation to local conditions, consult resources in
resistance management programs, your Cooperative Agricultural Extension
Service or your Elanco Animal Health representative (1-800-428-4441).
INHERENT RISKS OF USE
It is impossible to eliminate all risks associated with
the use of this product. Lack of performance or other unintended
consequences may result because of such factors as use of the product
contrary to label instructions, abnormal conditions, presence of other
materials, the manner of application, or other factors which are beyond
the control of Elanco Animal Health or the seller. All such risks are
assumed by the buyer.
LIMITATION OF REMEDIES
The exclusive remedy for losses or damages resulting
from this product (including claims based on contract, negligence,
strict liability, or other legal theories), shall be limited to, at
Elanco Animal Health’s election, one of the following:
(1) Refund of purchase price paid by buyer or user for product bought, or
(2) Replacement of amount of product used
Elanco Animal Health shall not be liable for losses or
damages resulting from the handling or use of this product unless Elanco
Animal Health is promptly notified of such loss or damage in writing.
To the extent permitted by law, Elanco Animal Health shall not be liable
for consequential or incidental damages or losses.
The terms of the Warranty Disclaimer and this Limitation
of Remedies cannot be varied by any written or verbal statements or
agreements. No employee or sales agent of Elanco Animal Health or the
seller is authorized to vary or exceed the terms of Warranty Disclaimer
of this Limitation of Remedies in any manner.
TERMS AND CONDITIONS OF USE
If terms of the Warranty Disclaimer, Inherent Risks of
Use, and Limitation of Remedies are not acceptable, return unopened
package at once to the seller for a full refund of purchase price paid.
Otherwise, use by the buyer or any other user constitutes acceptance of
the terms under Warranty Disclaimer, Inherent Risks of Use and
Limitations of Remedies.
Elanco warrants that this product conforms to the
chemical description on the label and is reasonably fit for the purposes
stated on the label when used in strict accordance with the directions,
subject to the inherent risks previously stated. Elanco MAKES NO OTHER
EXPRESS OR IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE OR ANY OTHER EXPRESS OR IMPLIED WARRANTY.
This pesticide is extremely toxic to fish and aquatic
organisms, and toxic to wildlife. To protect the environment, do not
allow pesticide to enter or run off into storm drains, drainage ditches,
gutters or surface waters. Applying this product in calm weather when
rain is not predicted for the next 24 hours will help to ensure that
wind or rain does not blow or wash pesticide off the treatment area.
Rinsing application equipment over the treated area will help avoid run
off to water bodies or drainage systems. This product is highly toxic to
bees exposed to direct treatment or residues on blooming crops or
weeds. Do not apply this product or allow it to drift to blooming crops
or weeds if bees are visiting the treatment area. Apply this product
only as specified on the label.
PHYSICAL AND CHEMICAL HAZARDS
Do not use or store near heat or an open flame.
Notice: Shake well before use. Avoid freezing. Read
entire label. Use only according to label directions. Before using this
product, read Warranty Disclaimer, Inherent Risks of Use, and Limitation
of Remedies at the end of the label booklet. If terms are unacceptable,
return at once unopened.
Elanco®, StandGuard®, and the diagonal bar are trademarks of Eli Lilly and Company.
Elanco Animal Health, A Division of Eli Lilly & Company, Indianapolis, IN 46285
Questions or comments call 1-800-428-4441
8 fl oz (237 mL)
NAC No.: 10310461